ENTIRE STORE IS 10% OFF. 3-5 DAY DELIVERY!

ONSRA Street Wheel Adapter Guide - Direct Drive Board only


This guide is only relevant if your ride a Direct Drive Board such as the ONSRA Black Carve Direct Drive. If you have a Belt Motor Board please visit the page of the ONSRA Pulley Guide - Black Carve Dual Belt only

ABEC Adapter

KEGEL Adapter

ABEC Adapter KEGEL Adapter
ABEC Core Kegel Core
ABEC Core
KEGEL Core
Top Speed 97mm Wheels: 32 MPH Top Speed 115mm Rubber Wheels: 33MPH
107mm Wheels
110mm Wheels
Top Speed 107mm Wheels: 32MPH Top Speed 110mm Wheels: 33MPH
ABEC
KEGEL
ABEC Adapter :
· ALUMINUM 7075 BLACK ANODIZED
· CNC Machined
· ABEC Core
· Matching Wheels: any ABEC Core Wheels, Abec11, Evolve, Cloudwheels (ONSRA ABEC core matching Discovery Core) and others. It is recommended to use wheels bigger than 97mm, up to 130mm).
· Packing: Two pieces in one set
KEGEL Adapter:
· ALUMINUM 7075 BLACK ANODIZED
· CNC Machined
· KEGEL CORE
Matching Wheels: any KEGEL Core Wheels, Orangatang, Torque Boards and others. It is recommended to use wheels bigger than 97mm, up to 130mm. .
· Packing: Two pieces in one set

 

All speeds are relatively rounded to the nearest 0.3 mph and are approximate numbers. Reaching a certain speed is influenced by wheel size, wheel width, wheel durometer, rider weight, weather, terrain, riding mode defined in remote, battery percentage and more. The numbers given are applicable to a 165 pound rider, riding on a full battery on flat terrain.

Please do not use AT wheels on the ONSRA Black Carve Direct Drive Board - it’s dangerous and can lead to serious injury.

The recommended wheel size for the ONSRA Black Carve Direct Drive Board is between 97mm up to 130mm, for the Dual Belt board it’s between 85mm and 180mm.

When you switch wheels make sure to switch the wheel size settings on your remote accordingly to the exact size of your wheel.
Riding with double kingpin trucks at high speed is only recommended for experienced riders wearing full protective gear (helmet, pads etc.). Make sure to tighten the trucks before your ride.